.png)
I made this card last month for our easter card challenge since we were in lockdown at the time we posted our creations on our facebook page & so this was my one.
So i first started off by prepping my card stock with my embossing powder tool (this stops flecks of embossing powder sticking to areas where it detects moisture like finger prints) & then stamping a few easter egg stamps from a stampin up set called basket bunch, with versa mark clear ink onto some white Fabriano bristol cardstock, then i grabbed out my white embossing powder from stampin up & spread it all over the card to cover all the eggs i had stamped.
Once i had completed that, i turned on my heat tool so i could melt the embossing powder till it turned shiny, then i got out some distress oxides in colours Peacock feathers, Twisted citron, Squeezed lemonade, Picked raspberry, Cracked pistachio & Spun sugar & also my blending brushes from taylor expressions & used them to ink blend the oxides onto the embossed cardstock then let it dry off for abot 10 minutes, then grabed a dry paper towel & buffed off any remaining oxdide ink sitting on the embossed easter eggs.
then i got out the bunny set called sweet little something from stampin up & got out my stamparatus to stamp the bunny’s onto some whisper white cardstock also from stampin up & some mini ink cubes from altenew in colours from lightest to darkest; sand dunes, rocky shore & mocha in the browns & sliver lake, gray denim & cloudy night in the gray & as this bunny stamp is a 3 step stamp i had to set them up in place to get them to stamp correctly so once that was completed with both bunny’s I got out my scan n cut & cut them out with a 4.0cm boarder.
Then i got out my ‘celebrate’ die from mft & cut it out once in glitter sliver cardstock & once with white cardstock & glued them both together with liquid adhesive to give the sentiment abit of height & then grabbed a scrap piece or black cardstock & again heat embossed the ‘easter’ word in white embossing powder.
After that a got out some pink ribbon & some red & white bakers twine for the two bows on each bunny then i added a little bit of liquid glue to the gray bunny’s ear & arm & attached them together with the brown one then put some foam tape on the back of each bunny for some added dimension & adhered the bunny’s & the celebrate die cut to the front of the card then adheared the easter word on top of the celebrate die cut with a small bit of foam tape, then added this to a black piece of cardstock from hero arts cut at 5 & 1/2″ by 4 & 1/4″ & then glued the black matted piece to a white card base & this card is complete.
If you have any questions reguarding the process of this card please contact me either by message or email, i’m only too happy to help!
Happy crafting!
Below are some of my affiliate links that if you use at Krafters cart while shopping I may get a small commission at no extra charge to you, this helps me to continue to purchase good quality stamps & dies to help me create beautiful cards with.